论文

论文题目 第一作者
Special Issue on Energy Storage Ding, YL
Effects of riser geometry on gas-solid flow characteristics in circulating fluidized beds Tu, QY
Collection efficiency in a three-dimensional randomly arranged dual-layer granular bed filter Chen, JL
Investigation of Numerical Evaluation Improvement for Three-Dimensional Infinite Cylindrical Heat Conduction Problems Pi, T
Release characteristics of gaseous products during CO2 gasification of char Xian, SX
Numerical investigation on heat transfer of supercritical carbon dioxide in the microtube heat exchanger at low reynolds numbers Cai, HF
Reconstruction method with the learned regularizer for imaging problems in electrical capacitance tomography Lei, J
Investigation and analysis of a fluidized bed dryer by process tomography sensor Wang, HG
Investigation on the co-combustion mechanism of coal and biomass on a fixed-bed reactor with advanced mass spectrometry Weng, JJ
Thermoeconomic assessment of a heat pump-enhanced steam and power cogeneration system under design and off-design conditions based on energy level-based exergy cost allocation method Liu, CC
Synthesis, Crystal Structure, and Optical Properties of the First Alkali Metal Rare-Earth Iodate Fluoride: Li2Ce(IO3)(4)F-2 Tang, CC
Aerodynamic load control on a dynamically pitching wind turbine airfoil using leading-edge protuberance method Zhang, YN
Thermodynamic analysis of a novel compressed carbon dioxide energy storage system with low-temperature thermal storage Zhang, Y
Investigation of gas-solids flow characteristics in a pressurised circulating fluidised bed by experiment and simulation Zhu, XL
Synergizing Photo-Thermal H-2 and Photovoltaics into a Concentrated Sunlight Use Tang, SL
Vertical Chemical Vapor Deposition Growth of Highly Uniform 2D Transition Metal Dichalcogenides Tang, L
Effect of HCl and CO on nitrogen oxide formation mechanisms within the temperature window of SNCR Zhao, J
Investigation of slagging characteristics and anti-slagging applications for Indonesian coal gasification Fan, YQ
Load control of floating wind turbine on a Tension-Leg-Platform subject to extreme wind condition Zhang, MM
One-dimensional modeling for tip clearance leakage vortex trajectory and stall-onset prediction in subsonic centrifugal impellers Zhang, CW
Numerical and experimental investigation of flow mechanism and application of tandem-impeller for centrifugal compressor Li, ZL
Effects of morphology and internal voids of copper ribs on heat transfer performance in copper foam/paraffin composite phase change materials Yang, X
Thermodynamic and exergy analysis of 2 MW S-CO2 Brayton cycle under full/partial load operating conditions Hu, HM
Role of copper grid mesh in the catalytic oxidation of CO over one-step synthesized Cu-Fe-Co ternary oxides thin film Waqas, M
Analysis of Instantaneous Vibrational Energy Flow for an Aero-Engine Dual-Rotor-Support-Casing Coupling System Ma, YQ
Effect of Different Flow Directions on Drag over Riblet Wang, J
Unsteady experimental and numerical investigation of aerodynamic performance in ultra-high-lift LPT Qu, X
Experimental investigation of thermal-hydraulic characteristics of a printed circuit heat exchanger used as a pre-cooler for the supercritical CO2 Brayton cycle Cheng, KY
Experiment study on collection and heat transfer characteristics of hot gas with coagulative particles flowing through a fixed granular bed with embedded heat exchange tubes Chen, JL
A general model for riblets simulation in turbulent flows Zhang, ZL